This build guide was written with the full permission and cooperation of cosplayer Mira Ashwood (@mira.makes on Instagram). All photos in this post are her own and used with permission.


Frieren’s staff is one of the most recognisable props in recent anime. It is also one of the most buildable: wooden texture, organic shapes, no LEDs, no moving parts. Mira Ashwood completed her build for $37 at a convention in September 2026. Here is her complete method.

Materials list

ItemCostSource
5ft wooden dowel rod, 1 inch diameter$6Hardware store
EVA foam sheet, 10mm$8Craft store
Contact cement$5Hardware store
Acrylic paint set (brown, grey, black, white)$9Craft store
Fine sandpaper (220 grit)$3Hardware store
Mod Podge matte sealant$6Craft store

Total: $37

Step 1: Shape the top piece

Mira used a printed reference sheet from the official Frieren artbook (not included here to avoid reproducing copyrighted material – search “Frieren staff reference” for fan-compiled sheets). She cut the branching top piece from two layers of 10mm EVA foam glued together, then carved the edges with a rotary tool to round them.

Step 2: Attach to dowel

The dowel was roughed up with sandpaper at the top 6 inches, then coated with contact cement on both the dowel and the foam piece. After 60 seconds of dry time, she pressed them together and held for two minutes.

Step 3: Texture

The woody texture was created by pressing a crumpled piece of aluminium foil firmly into the foam surface while it was still warm from a heat gun pass. This took practice on scrap pieces first.

Step 4: Paint

Base coat in dark brown. Dry-brush grey over the top piece. Add black in the deep grain lines with a fine brush. Final dry-brush of off-white to pick up high points. Two coats of Mod Podge matte to seal.

Final result

The complete staff weighs under 400g and passes convention prop checks (no sharp edges, no rigid metal). Mira used it at three events without damage.


Questions? Mira answers build questions via her Instagram. Full photo set is on her page.